三菱 M700VM70V系列 三菱-M700VM70V系列 便攜式說明書 -英
資料介紹：
P920 No spec: 3D coord conv
Details There is no specification for 3-dimensional coordinate conversion.
Remedy - Check the specifications.
P921 Illegal G code at 3D coord
Details The commanded G code cannot be performed during 3-dimensional coordinate conversion
modal.
Remedy - Refer to "MITSUBISHI CNC 700/70 Series Programming Manual (Machining Center Sys-
tem)" for usable G commands.
- When the basic specification parameter "#1229 set01/bit3 (Initial constant surface speed)"
is enabled, disable the parameter or issue the constant surface speed control cancel (G97)
command.
P922 Illegal mode at 3D coord
Details A 3-dimensional coordinate conversion command was issued during a modal for which 3-di-
mensional coordinate conversion cannot be performed.
Remedy - Refer to "MITSUBISHI CNC 700/70 Series Programming Manual (Machining Center Sys-
tem)" for usable G commands.
P923 Illegal addr in 3D coord blk
伺服驅動器 MR-J2S-200A4
伺服電機電源用電纜 MR-PWS1CBL5M-A1-L
伺服電機 HC-MFS43
編碼器用電纜 MR-EKCBL20M-H
伺服電機 HC-MFS23
編碼器電纜 MR-JHSCBL2M-L
SSCNET Ⅲ 光纖 MR-J3BUS03M
PLC FX2N-32MS-E/UL
伺服電機 HC-MFS73
可編程控制器 FX1N-60MR-001
存儲卡 FX-EEPROM-16
伺服放大器 MR-J2S-55KB4
PLC FX2N-32MT-E/UL
伺服馬達 HF-MP43
編碼器接頭 MR-J3ENCBL5M-A1-L
PLC FX2N-32MR-001
PLC FX3U-64MT/ES-A
伺服控制器 MR-J2S-700B
PLC FX1S-14MT-001
CN4電纜 MR-H3CBL1M
伺服電機電源用電纜 MR-PWS1CBL10M-A1-H
PLC FX2N-32MT-ES/UL
伺服電機 HC-MFS13D
編碼器電纜 MR-JCCBL30M-L
PLC FX1S-14MT-D
Q系列PLC線性快閃存儲卡 Q2MEM-4MBF
接頭套件 MR-ECN1
PLC FX2N-48MT-DSS
RGB輸出單元 GT16M-ROUT
PLC FX3U-32MR/DS
上一條：
下一條：相關下載
